Depth Raider Coated Downrigger Cable Part #DR-1060 CHOOSE YOUR LENGTH!!!

Product Description

Depth Raider Marine Products

COATED DOWNRIGGER CABLE
Part # DR-1060 Model

Kell Laboratories

EACH SOLD SEPARATELY!!!CHOOSE YOUR LENGTH!!!

Coated downrigger cable is necessary to prevent the lake water from absorbing (attenuating) the signal transmitted from the sensor/transmitter unit. The coating provides electrical isolation from the water since water is a conductor of electricity. Without the coating (or electrical isolation), a portion of the signal is absorbed by the water thereby reducing the signal level at the receiving antenna. Without the coating, as the depth of the probe continues to increase, the signal level at the antenna continues to degrade until it is no longer adequate for proper interpretation by the receiver/display unit. It should be noted that the actual depth of operation without a coated cable can vary greatly from installation to installation, boat to boat, water conditions, etc.

While the Depth Raider system will operate to varying depths without the coated cable; installation of the coated cable is highly recommended to provide proper operation to 200 feet.

COMPATIBLE with MOOR

Length Available: Part #DR-1060

200 Feet 

300 Feet

400 Feet

WARNING: This product can expose you to chemicals, including lead which is known to the State of California to cause cancer or other reproductive harm. For more information go to www.p65Warnings.ca.gov.